The F350 series is a versatile, high performance, air velocity and air temperature sensor where the sensor element is built remotely from the sensor electronics.
The Accu-CT revenue grade, split-core current transformer offers outstanding linearity and phase angle accuracy with a unique one-handed opening and closing mechanism.
The Accu-CT ACTL-1250 series split-core current transformer (CT) offers revenue grade performance with a unique one-handed opening and closing mechanism
The Advanced Pulse WattNode is a true RMS AC watt-hour transducer with pulse output proportional to kWh consumed. The WattNode provides accurate measurement at low cost to meet your needs for sub-metering, net-metering, energy management, and performance contracting applications.
The CDI 5200 clamps onto a pipe, with two flow-sensing probes projecting into the pipe through 3/16-in. drilled holes. It seals directly to the pipe; no cutting or welding is required for installation. Because each flowmeter is made and calibrated for a specific size of pipe, the digital display indicates flow directly, with no setup or adjustment.
The CDI 5400 clamps onto a pipe, with two flow-sensing probes projecting into the pipe through 3/16-in. drilled holes. It seals directly to the pipe; no cutting or welding is required for installation. Because each flowmeter is made and calibrated for a specific size of pipe, the digital display indicates flow directly, with no setup or adjustment.
The duct CO2 sensor CDK is a maintenance-free, micro- processor-controlled unit designed for duct installation and is used to detect the CO2 content of the air.
The VCP Carbon Monoxide (CO) Detectors with a measuring range up to 300ppm are suitable for CO measurement in parking garages, tunnels, engine repair shops, loading bays, engine test benches, shelters, go-kart race courses etc.
The small size 5 to 75 AMP split-core AC Current Transformers (CT) are mounted around a current carrying wire to measure AC amperage. This CT provides a 0 to .333 Volt AC output proportional to current flow and are used with Onset loggers.
The pHionics STs Series™ pH sensor provides accurate pH and temperature measurements from 0-14pH to a datalogger or RTU for continuous water quality monitoring.
The pHionics STs Series™ Dissolved Oxygen sensor accurately measures dissolved oxygen (0-20 mg/L or percent saturation) and temperature (0-50°C) over long periods of time with little maintenance required.
The pHionics STs Series™ ORP sensor provides reliable ORP (redox) and temperature measurements to a datalogger, RTU, PLC, or SCADA system for continuous water quality monitoring.
Thermal massflow sensor for compressed air and gases. With our VA500 it is possible to monitor your consumption and analyze your leakage flows with just one measuring device.